Exclusive FKL distributor for the Slovak Republic

  1. Home
  2. Products
  3. Standard Program
  4. Y Bearing Units
  5. Housing Type S
  6. UES 205 2S

UES 205 2S

Y-Bearing Plummer Block Units With Grey Cast Iron Housing "S"

25mm
d · Bore diameter
140mm
L · Overall length
14kN
Cdyn · Dynamic load rating
7.8kN
Co · Static load rating
0.7kg
kg · Mass

Price & availability

Check the current price and stock availability of this product in our e-shop.

Check at eloziska.sk

Our e-shop · PO BEARINGS s.r.o.

Designation: UES 205 2S

Cross references

ManufacturerDesignation / part number
INAPASEY25-N
SNRUSP205
SNRUSPE205

Type equivalents according to FKL's interchange table (Ball Bearings and Bearing Units catalogue, section 3.3). Each designation has been checked for this size in that maker's own catalogue; compare the dimensions before ordering.

What the designation means

2S
One lip rubber metal seal (on both sides)
All prefixes and suffixes

Downloads

UES 205 2S

Technical specifications

Dimensions and load ratings – symbols refer to the technical drawing.

SymbolParameterValue
dBore diameter25mm
LOverall length140mm
AHousing contact surface width38mm
A1Width of the top of the housing24mm
HHousing height69.5mm
H1Distance from the contact surface to the bearing axis36.5mm
H2Housing foot thickness16mm
JminMin. distance between the holes94mm
JmaxMax. distance between the holes111mm
NDiameter of attachment slot13mm
N1Length of attachment slot21.5mm
s1Distance from locking device side face to raceway centre19.5mm
kgMass0.7kg
CdynDynamic load rating14kN
CoStatic load rating7.8kN
PuFatigue load limit0.335kN
Sealing type

S SEAL / S SEAL (2S)

Single lip seal with the labyrinth between the sheet part and the rubber lip which conducts the contact sealing. The friction and speeds are the same as with RS but provides much better protection against the rough impurity particles. This is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides contact sealing which prevents penetration of finer impurities, water, moisture, steam etc. Suitable for neutral conditions because of the presence of the foreign materials. It is used with the Y bearing (standard) and deep groove ball bearings.

Overview of all sealing types
Technical drawing – UES 205 2S
Technical drawingClick to enlarge